The lamp tube is stacked in the special material trough and automatically climbs to the corresponding work station with the chain drive. The lamp tube positioning mechanism lifts eight glass tubes at a time, and the shaping clamping and positioning are completed. Then the positioning rod lifts eight light source plates, while gluing, inserts them into the glass tube. After reaching the holding position, the lamp tube positioning mechanism sinks as a whole, realizing the light source plate and glass. After several seconds of holding pressure, the lamp positioning mechanism was lifted as a whole, and the light source plate was separated from the positioning rod. Later, the positioning rod was pulled out from the glass tube to complete a coating and pasting cooperation.

Equipment features:

1. Designed for gluing of LED T8 glass lamp tube. Eight lamp tubes are glued at the same time. The designed capacity is 1000 pieces per hour.

2. Compatible lamp length is 600mm, 900mm, 1200mm, 1500mm;

3.8 rubber paths are respectively matched with independent dispensing valves, with precise glue output, quick glue opening, clean glue breaking, no wire drawing, no dripping and leakage;

4. While laying the light source board manually, the lamp tube automatically loads and unloads, which improves the production efficiency and reduces the labor force.

5. Pressure-holding bonding time can be set arbitrarily by touch screen according to the characteristics of glue.

6. Each dispensing valve is equipped with a separate oil cup under it, which can prevent the rubber head from curing when it is not working.

7. Dual barrel design, when one barrel is less glue, the system will automatically alarm, and switch to another barrel for glue supply, which can be produced while changing glue, without stopping to change glue;

8. The whole machine is divided into two parts, which can be disassembled and transported.

9. The gluing function of FPC flexible board can be upgraded.